







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Why Pasadena Homeowners Choose Unilock Construction
We provide independent Unilock construction service in Pasadena, CA – installation and repair of Unilock paver driveways, patios and retaining walls by technicians who have up to 12 years of experience with the brand’s units. What separates our Unilock work is base preparation and joint sand detail built for Pasadena’s soil and summer heat, not a generic slab-and-sand approach. We install and service Unilock products; we are not authorized, sponsored or certified by Unilock, and we say so plainly.
Pasadena is a demanding place to put pavers down. Historic districts around Bungalow Heaven and Prospect Park mean exterior work can pull in design review, and hillside lots above the Arroyo test drainage in ways flat-lot work never does. Unilock units hold up well here when the base is right. When it isn’t, you see it within a couple of seasons.
Call (844) 905-4587 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Key Takeaways
- We install and repair Unilock pavers and wall systems as an independent contractor, not a Unilock dealer.
- Base compaction and joint sand cause most of the paver failures we see in Pasadena.
- We match existing Unilock color and dimension where the line is still produced, and source compatible alternatives when it isn’t.
- Typical paver driveway installation in Pasadena runs $7,000 – $18,000; the written estimate sets the final price.
Why Trust Construction Pasadena for Your Unilock Construction?

Our technicians know how Unilock units behave in the ground. That means knowing that a Brussels Block driveway in Pasadena fails at the edges first, where the base meets the garage apron and drainage concentrates. It means knowing that a Prest brick paver surface facing west into the afternoon sun will fade faster than the same product under a shade tree, and that a sealer applied too early traps moisture and makes efflorescence worse, not better.
We use quality replacement pavers and wall units that fit Unilock installations. On current lines we source genuine Unilock units so color and dimension match the rest of the field. On discontinued lines we identify compatible alternatives from other manufacturers and show you samples before anything is ordered, so there’s no surprise when the pallet lands.
Warranty-safe practice is part of the job. We follow the base depth, compaction and joint sand requirements that keep an installation eligible for coverage, we don’t cut corners to save a day, and we document what was installed and how. If a manufacturer warranty question comes up later, you’ll have the record.
Pasadena properties come with their own complications. Knob-and-tube wiring and old clay sewer laterals in pre-1950 homes sit under a lot of these driveways, and we plan excavation around them rather than through them. On sloped lots in the Arroyo area, drainage design comes before the first paver goes down.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Common Unilock Construction Problems We Fix in Pasadena
These are the failures we’re called out to look at most often. None of them are unusual. Most trace back to installation conditions rather than the units themselves.
- Efflorescence on Brussels Block and other cement-based pavers. That white chalky film is mineral salt migrating to the surface as moisture moves through the paver. Pasadena’s seasonal moisture swings and a sealer applied over a damp surface both make it worse. The fix is cleaning, correcting the moisture path, and sealing at the right time of year – not scrubbing it off and hoping.
- Joint sand erosion and paver shifting. Heavy rain running off a roof or a slope washes joint sand out, and once the joints open the units start to move. Older Pasadena driveways with shallow or under-compacted base are the ones that develop this first. Re-sanding holds for a while; re-leveling the base is the real repair.
- Color fading and surface wear on Prest brick pavers. Intense UV over years dulls the surface, and unsealed pavers with no periodic resealing lose color depth faster. Fading is cosmetic, but it’s the reason a driveway that’s structurally fine can still look tired. A clean and reseal brings most of the color back.
- Cracking or leaning U-Cara retaining wall units. On hillside lots, a wall system needs drainage behind the units and, where height and soil pressure call for it, geogrid reinforcement. Without either, water builds up, the wall leans, and units crack at the joints. This one gets worse fast and is worth looking at early.
- Uneven spots and loose pavers near the garage apron. A common pattern after winter rains: the base wasn’t compacted to proper depth, or joint sand washed out over time. Lifting the affected units, recompacting, adding fresh joint sand and re-laying usually restores a flat, stable surface.
One thing that makes this page different from a manufacturer’s product page: we can tell you which of these is worth fixing and which is throwing money at a base that will fail again. That call depends on what’s under the pavers, and we only know that after we open it up.
Unilock Parts & Our Repair-vs-Replace Approach

We don’t stock Unilock parts, and we’re not a Unilock dealer. What we do is source genuine Unilock replacement pavers and wall units whenever they’re available, so a repair blends into the existing field instead of reading like a patch. For discontinued lines, we identify compatible aftermarket alternatives from quality manufacturers and get your approval before ordering.
Repair before replace is our default. Re-sanding joints, re-leveling a settled section, or swapping a handful of cracked units can add years to an installation that’s mostly sound. Full tear-out makes sense when the base itself has failed across the whole field, when drainage is directing water under the pavers, or when the wall system has moved enough that reinforcement won’t hold it.
We’ll tell you which situation you’re in and what each path costs. Call (844) 905-4587 for a free estimate – we’ll look at the failure, not just the surface.
Our Unilock Service Process – Step by Step
- 1
Diagnosis. We walk the installation, check joint sand depth, look for efflorescence patterns, probe for soft spots, and on wall systems check for lean and drainage behind the units. On hillside lots we look at where water actually goes.
- 2
Repair or install. For repairs, we lift affected units, correct the base and re-lay. For new work, we excavate to depth, compact in lifts, set edge restraint and lay the Unilock units to the pattern you’ve chosen.
- 3
Joint sand and sealing. We fill joints with the right sand, compact again, and recommend a sealer on a schedule that fits Pasadena’s seasons – not immediately after installation when moisture is still moving.
- 4
Walkthrough and record. We walk the finished work with you, hand over what was installed and how, and leave you with maintenance guidance that keeps the installation warranty-eligible.
See the difference
Before
After
Before
After
Before
AfterUnilock Products We Service & Install in Pasadena

We work with Unilock’s paver and wall systems: Brussels Block for driveways and patios, Prest brick pavers for driveways and walkways, Elegance pavers for patio and pool-deck surfaces, and the U-Cara wall system for retaining walls and raised planters. We install new, repair existing, and handle driveway replacement where the base has gone.
Pasadena driveways and patios are the bulk of what we’re asked about, and paver patio installation typically runs $3,500 – $11,000. We work across the city, from the historic districts near Orange Grove Boulevard to the mid-century tracts on the east side.
Typical Unilock Project Costs in Pasadena
These are typical estimated ranges for Pasadena. The written estimate sets the final price after we’ve seen the site.
| Service | Typical Estimated Range |
|---|---|
| Paver Driveway Installation | $7,000 – $18,000 |
| Paver Patio Installation | $3,500 – $11,000 |
| Driveway Replacement | $5,000 – $14,000 |
| Driveway Sealing | $250 – $700 |
Here’s how a typical job usually goes. A homeowner notices uneven spots and loose pavers near the garage on a Brussels Block driveway, most obvious after winter rains. The usual cause is a base that wasn’t compacted to proper depth, or joint sand that has washed out over time. A qualified local pro lifts the affected pavers, recompacts the base, adds fresh joint sand, re-lays the units, and often recommends a sealer to prevent the erosion from returning.
We Also Service These Brands
Unilock is one of six hardscape manufacturers we work with. We also install Belgard, Tremron, Techo-Bloc, Cambridge Pavers and Oldcastle systems, and our interior work runs on KraftMaid cabinets, Cambria and Silestone quartz surfaces, and Kohler fixtures. One contractor across the driveway and the kitchen means you’re not coordinating three trades on a project that touches both. Material choices, not material surprises.
FAQs – Unilock Construction Service in Pasadena
No. We are an independent Unilock service provider in Pasadena. We are not authorized, sponsored or certified by Unilock, and we don’t present ourselves as a dealer. We install and repair Unilock products based on hands-on experience with them.
Yes. We source genuine Unilock replacement pavers and wall units whenever they’re available so color and dimension match, and for discontinued lines we identify compatible alternatives from quality manufacturers. You approve the material before it’s ordered.
Most repairs are a one- to two-day job once materials are on hand. Paver driveway installation typically takes several days depending on square footage, base work and drainage needs. Your written estimate lays out the expected timeline.
We install and repair Unilock paver systems for driveways, patios and walkways, and the U-Cara wall system for retaining walls and raised planters. If it’s a Unilock hardscape product, ask – we’ll tell you straight whether we cover it.
Properly done repair and installation shouldn’t void a manufacturer warranty, but coverage depends on the terms of your specific product warranty. We follow base, compaction and joint sand requirements that keep installations warranty-eligible and document what was done.
Paver driveway installation typically runs $7,000 – $18,000 in Pasadena, paver patio installation $3,500 – $11,000, driveway replacement $5,000 – $14,000, and driveway sealing $250 – $700. Estimates are free. Call (844) 905-4587 for an exact quote.
Usually, yes. Brussels Block is a current Unilock line, so we can source genuine units that match color and dimension. Where a line has been discontinued, we find a compatible alternative and show you a sample first. Call (844) 905-4587 to schedule a look.
You stop it at the source. Efflorescence is mineral salt rising with moisture, so the fix is correcting drainage, letting the pavers dry fully, cleaning the salt off, and sealing at the right time of year instead of immediately. Sealing over a damp surface traps moisture and makes it return.
The base needs to be excavated to depth, compacted in lifts, and graded so water moves away from the house and garage. Pasadena’s sloped lots and Arroyo-area drainage make grading the part most likely to be rushed. Get it right and the pavers stay flat.
Repair usually wins when the wall lean is minor and the cause is drainage that can be corrected. If units have cracked through and the wall has moved significantly, reinforcement won’t hold it long. We check drainage and geogrid before recommending either path.
Decades, when the base is compacted properly and joints are maintained. Pasadena’s heat and UV will dull the surface and require periodic resealing, but fading is cosmetic. Base failures and joint sand erosion are what actually shorten an installation’s life.
Book Your Unilock Service in Pasadena, CA
Whether it’s a Brussels Block driveway that’s gone uneven, a U-Cara wall that’s leaning, or a new paver patio you’re planning, we’ll look at it and give you a written estimate with the line items spelled out. Call (844) 905-4587. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Construction Pasadena.












